In this case we can see one of the most common faults in electric motors, damage the stator resulting from short-circuit a phase, which led to an explosion and damage the stator.

After the diagnosis and inspection was budgeted and reported to our customer after award, we proceed to repair the generator.

First, the motor data were taken. Then the generator was unwound, cleaned and painted inside. After cleaning and painting, both the stator and the rotor were wound with all the insulation required to prevent further damage by short circuit, varnished and dried in an oven. The rotor has been properly calibrated to avoid another common fault in the electric motors that are mechanical imbalances and misalignments. Finally they were replaced bearings and mounted to the generator again proceeded to the test and it was found that the controller does not allow the generator to provide the appropriate voltage, then performing replacing the controller with a newer. < / p>

After retesting, it was found that the generator was operational again, communicated to the customer that came to seek the satisfaction of service quality, price and delivery time.

In this case the type of fault is a short circuit phase.

After the diagnosis and inspection was budgeted and reported to our customer after award, proceed to engine repair.

First, the motor data were taken. Then the engine was unwound, cleaned and painted inside. After cleaning and painting, the stator is wound with all the insulation required to prevent further damage by short circuit, varnished and dried in an oven. Finally they were replaced bearings and is mounted again the engine and proceeded to the test.

At the end communicated to the customer that came to seek the satisfaction of service quality, price and delivery time.

In this case one of the bombs had good winding but the turbine was completely damaged, the other pump had a short circuit in the stator.

After the diagnosis and inspection was budgeted and reported to our customer after award, we proceeded to repair the pumps.

Firstly, the data were removed engines.

The first bomb was made a review with cleaning, replacing seals, oil replacement, bearings and damaged turbine, finally the engine was painted.

The second pump is uncoiled, cleaned and painted inside. After cleaning and painting, the stator is wound with all the insulation required to prevent further damage by short circuit, varnished and dry in the oven. Finally were replaced the bearings, seals and oil, it set up the pump again and proceeded to his trial.

At the end communicated to the customer that came to seek the satisfaction of service quality, price and delivery time.